6.2.3 Switching off
î™®
trigger the circuit breaker located at the base of the centre console
 Let the motor run under no load for 1 to 2 minutes to allow it to cool.
î™° press the "STOP" button to stop the generating set.
î™± switch off the MICS Nexys module by switching the key to "OFF" (without forcing it).
6.2.4 Alarms and faults
The appearance of a fault or an alarm causes the following
screen to be displayed (one or more pictograms or a fault
code along with the SOS message are displayed).
The user can access the following screens by pressing the key
The fault or alarm screen will disappear once the fault or alarm has been removed.
Only one fault is displayed on this screen (the fault which caused the generating set to stop).
If one or more faults have appeared after the first fault, they can only be displayed after the first fault has been reset
(press "Reset" as many times as the number of faults present).
Note: an alarm can appear at the same time as a fault.
6.2.5 Faults and alarms - Details
List of faults which will cause the generating set to stop and generate a pictogram
Oil pressure fault: Indicates that the oil pressure is incorrect
Associated pictogram
Engine temperature fault: Indicates that the engine
temperature is too high.
Associated pictogram
Non-starting fault: Indicates that there have been three
consecutive unsuccessful starting attempts.
Associated pictogram
Overspeed fault: Indicates an excessive generating set
running speed.
Associated pictogram
Low fuel level fault: Indicates the need to top up the fuel.
Associated pictogram
To Next Page
Loading...
Need help?
General
