3.2. Choice of location
This shall be determined according to the application. There are no strict rules governing the choice of location, other than the proximity
of the electrical supply panel and the disturbance caused by the noise. However, it is important to take into account the fuel supply, the
evacuation of burnt gases, the direction of these gases and evacuation noises.
The choice of location will therefore be the result of a carefully considered compromise!
Examples of problems that may be encountered:
Incorrect ventilation and exhaust Building or terrain too rough.
Generating set incorrectly seated
Reduced access
Impossible to fill with fuel Impossible to open enclosure doors
Figure 3.1: Examples of problems that may be encountered
Ensure that the generating set is placed on a flat surface.
Warning
3.3. Moving the genset
Whenever the generating set is moved, the appropriate equipment must be used (sling, forklift, etc.) and you must know the parts of
the generating set which enable it to be moved ( see below).
î™® Central lifting ring
 Forklift pockets
î™° Drawbars
To Next Page
Loading...
Need help?
General
