PRE-RIDE INSPECTION
WARNING
Perform a pre-ride inspection before each ride to detect potential problems
during operation. The pre-ride inspection can help you monitor wear and
deterioration before they become a problem. Correct any problems that
you discover to reduce the risk of a breakdown or crash. See an authorized
Sea-Doo dealer as necessary.
Before performing the pre-ride inspection, read and understand the
CONTROLS
section.
What to Do Before Launching the Watercraft
WARNING
Engine should be off and the tether cord cap should always be removed
from engine cut-off switch prior to verifying any of the following points.
Only start watercraft once all items have been checked and operate prop-
erly.
Check the items listed in the following table before launching the watercraft.
ITEM OPERATION
✓
Hull Inspect.
Jet pump water intake Inspect/clean.
Bilge Drain. Ensure plugs are secured.
Battery
Inspect tightness of cables and retaining
fasteners.
Fuel tank Refill.
Engine compartment
Check for any fluid leaks and gasoline vapor
odor. Verify fuel exhaust components integri
ty.
Engine oil level
Check/refill.
Engine coolant level
Check/refill.
Steering system and side
vanes (O.P.A.S.™)
Check operation.
Throttle system
Check operation.
Shifter system Check operation.
Variable Trim System (VTS) Check operation.
Storage compartment covers
and seat
Ensure they are closed and latched.
Self-contained removable
storage bin
Ensure it is installed on watercraft and properly
closed and latched.
Engine start/stop button
Check operation.
Engine cut-off switch
Check operation.
28
_______
SAFETY I
NFORMATION
________
To Next Page
Loading...
Need help?
General