MAINTENANCE PROCEDURES
smo2007-002-007_b
MODELS WITHOUT AN ENGINE COVER
1. Oil filling cap
NOTE: Every time oil is added in en-
gine, the complete procedure ex-
plained in this section must be carried
out again. Otherwise, you will have a
false oil level reading.
9. Properly reinstall oil cap and dip-
stick.
Engine Oil Change and Oil Filter
Replacement
The oil change and filter replacement
should be performed by an authorized
Sea-Doo dealer.
Engine Coolant
Recommended Engine Coolant
Always use ethylene-glycol antifreeze
containing corrosion inhibitors specif-
ically formulated for internal combus-
tion aluminum engines.
NOTE: When available, it is recom-
mended to use biodegradable an-
tifreeze compatible with internal com-
bustion aluminum engines. This will
contribute to protect the environment.
Cooling system must be filled with wa-
ter and antifreeze solution (50% dem-
ineralized water, 50% antifreeze).
BRP sells premixed coolant with freez
-
ingprotectionupto-37°C(-35°F)
(P/N 293 600 038).
NOTE: Using a blend of 40% an-
tifreeze with 60% demineralized wa-
ter will improve the cooling efficiency
when the watercraft is used in partic-
ularly hot weather and/or hot water
condition.
To prevent antifreeze deterioration, al-
ways use the same brand. Never mix
different brandsunless cooling system
is completely flushed and refilled. Re-
fer to an authorized Sea-Doo dealer.
Engine Coolant Level
WARNING
Check coolant level with engine
cold. Never add coolant in cooling
system when engine is hot.
CAUTION Certain compo-
nents in the engine compartment
may be very hot. Direct contact may
result in skin burn.
Remove seat(s) to expose cooling sys-
tem expansion tank.
smo2007-002-005_c
TYPICAL
1. Expansion tank
2. Cap
With watercraft on a level surface, liq-
uid should be between MIN. and MAX.
level marks of coolant reservoir when
engine is cold.
_______________
69
To Next Page
Loading...
