MAINTENANCE PROCEDURES
F07E01Y
3
21
TYPICAL
1. Hose adapter
2. Quick connect adapter (optional, not
mandatory)
3. Garden hose
To flush, start the engine then immedi-
ately open the water tap.
CAUTION Certain compo-
nents in the engine compartment
may be very hot. Direct contact may
result in skin burn. Do not touch
any electrical parts or jet pump area
when engine is running.
NOTICE
Never flush a hot en-
gine. Always start the engine before
opening the water tap. Open wa-
ter tap immediately after engine is
started to prevent overheating.
Run the engine about 20 seconds at a
fast idle between 4000 - 5000 RPM.
NOTICE
Never run engine without
supplying water to the exhaust sys-
tem when watercraft is out of water.
Ensure water flows out of jet pump
while flushing. Otherwise, refer to an
authorized Sea-Doo dealer for servi
c-
ing.
NOTICE
Never run engine longer
than 2 minutes. Drive line seal has
no cooling when watercraft is ou
tof
water.
Close the water tap, then stop the en-
gine.
NOTICE
Always close the water
tap before stopping the engine.
NOTICE
Remove quick connect
adapter after flushing operation (if
used).
Throttle Body
Throttle Body Lubrication
Lubricate throttle body with XPS Lube
or an equivalent.
Use fitting for that purpose provided in
the engine compartment.
With the engine not running, make
sure to spray lubricant at least 3 to 5
seconds for proper lubrication.
smo2010-001-007_a
TYPICAL — GTS PRO MODEL
1. Fitting
smo2008-001-052_a
TYPICAL — RXP-XMODEL
1. Fitting
_______________
73
To Next Page
Loading...
Need help?
General