MONITORING SYSTEM
Beeper Code Information
BEEPER CODES DESCRIPTION
Bad D.E.S.S. system connection.
Reinstall tether cord correctly ON engine cut-off switch.
Wrong D.E.S.S. key.
Use a D.E.S.S. key that has been programmed for the watercraft.
Defective D.E.S.S. key.
Use another programmed D.E.S.S. key.
Dried salt water in tether cord cap.
Clean tether cord cap to remove salt water.
Defective engine cut-off switch.
Refer to an authorized Sea-Doo dealer.
1 Long Beep
(while installing tether cord
on watercraft engine cut-off
switch)
Improper operation of ECM or defective wiring
harness.
Refer to an authorized Sea-Doo dealer.
1 Short Beep
followed by 1 long beep
ECM has been mistakenly set to onboard diagnostic
mode.
Remove and reinstall tether cord.
4 Short Beeps
at different interval for
4 hours
tether cord has been left on the engine cut-off switch
without starting engine or after engine was stopped.
To prevent battery discharge, remove the tether cord from the
engine cut-off switch.
Watercraft is upside down.
Turn watercraft upright. Refer to
SPECIAL PROCEDURES
.
A 2 Seconds Beep
every 15 minutes interval
Engine management system fault.
Refer to an authorized Sea-Doo dealer.
Low fuel level.
Refill fuel tank. If problem persists, refer to an authorized
Sea-Doo dealer.
A 2 Seconds Beep
every 5 minutes interval
Fuel tank level sensor or circuit malfunction.
Refer to an authorized Sea-Doo dealer.
High engine temperature coolant.
See
ENGINE OVERHEATING
.
High exhaust temperature.
Refer to an authorized Sea-Doo dealer.
Continuously Beeps
Low oil pressure.
Turn off engine as soon as possible. Check oil level and refill.
RefertoanSea-Doodealer.
NOTICE
If the monitoring beeper continuously sounds, stop engine as
soon as possible.
_______________
97
To Next Page
Loading...
Need help?
General