PRE-RIDE INSPECTION
Shifter System
Check reverse gate operation for free-
dom of movement.
With shift lever in forward position, the
gate should be in upward position; of-
fering a resistance to go downward.
With the shift lever in neutral position,
the gate should be in the middle posi-
tion.
With the shift lever in the reverse po-
sition, the gate should be in the down-
ward position.
WARNING
Verify the reverse gate operation
before starting the engine. Ensure
no one is near the gate when the
shift lever position is changed.
Variable Trim System (VTS)
RXP-X 255 Model
Install tether cord then alternately
press the VTS up and down button
to check nozzle movement. The VTS
position indicator movement can also
be seen in the information center.
Storage Compartment
Covers and Seat
Ensure all required safety and survival
equipment and any additional cargo is
properly stored in the storage bins pro-
vided.
Ensure the self-contained storage
bin cover, front cover, glove box, ac-
cess panels, and seat are closed and
latched.
WARNING
Ensure the seat, access panels,
and all storage compartment cov-
ers are securely latched.
Engine Start/Stop Button
Position shift lever in neutral. Start
engine and stop it using the engine
start/stop button.
WARNING
If engine does not shut-off when
pushing engine start/stop button,
do not operate the watercraft fur-
ther, see an authorized Sea-Doo
dealer.
Engine Cut-Off Switch
Verify when pulling off the tether cord
from the engine cut-off switch that en-
gine can be stopped.
WARNING
Do not use watercraft if engine can
not be stopped by pulling off the
tether cord.
________
SAFETY INF
ORMATION
________
31
To Next Page
Loading...
Need help?
General