Sea Tel 14400MK2-21 - Home Flag Position; Bde; Setup

14400MK2-21 C/Ku-Band TVRO Installation
3-21
If any of these steps fail, or the ACU reports model "xx97", re-configure the PCU as described in the Setup
section of this manual. If initialization still fails, this indicates a drive or sensor problem, refer to the
Troubleshooting section.
3.9.2. Home Flag Position
Note the approximate position of the antenna relative to the bow of the ship while it is at the home switch
position. This information will be used later to calibrate the relative position display of the antenna.
3.9.3. BDE
Turn Power ON to the ACU. Record the power-up display, Master (ACU) Model & Software version and the
Remote (PCU) Model & Software version.
3.10. Setup
Refer to the Setup information in the next section of this manual and in the Setup section of your ACU Manual.