Secutron MMX-2003-12NDS - User Manual

48 pages

Save Page as PDF

To Next Page

Intelligent Fire Alarm Network

User Guide

MMX

LT-893SEC Rev 1

May 2017

Main Page

Other manuals for Secutron MMX-2003-12NDS

Application Guide217 pages

Questions and Answers

E
Erik ClarkSep 8, 2025
What does 'Data Link Failure' mean on my Secutron Fire Alarm?
- G
  gshannonSep 8, 2025
  The 'Data Link Failure' message on Secutron Fire Alarms displays if the panel cannot communicate with a remote annunciator or an internal CPU on an adder module.
D
derrickmitchellSep 12, 2025
Why am I getting a 'Data Link Trouble' message on my Secutron Fire Alarm?
- A
  Adam RoweSep 12, 2025
  The 'Data Link Trouble' message on Secutron Fire Alarms indicates that the panel has a communication error with a remote annunciator.
T
Taylor RossSep 12, 2025
What does 'Program Version Mismatch' mean on my Secutron Fire Alarm's RAXN-LCD?
- J
  Jamie ReynoldsSep 13, 2025
  The 'Program Version Mismatch' message on Secutron Fire Alarms (displayed on the RAXN-LCD only) means that the RAXN-LCD firmware version is not compatible with the FX-2000N firmware version.
D
Debra JonesSep 14, 2025
How do I fix 'Configuration Data Error (RAM)' on my Secutron Fire Alarm?
- N
  Nicholas KingSep 14, 2025
  The 'Configuration Data Error (RAM)' message on Secutron Fire Alarms indicates that the system is overloaded and risks resetting itself. Reload the Configurator and/or reboot the system by powering it down and then powering it up.
J
Joseph SmithSep 17, 2025
What should I do if my Secutron Fire Alarm displays 'Configuration Data Error (FLASH)'?
- H
  huntgailSep 17, 2025
  The 'Configuration Data Error (FLASH)' message on Secutron Fire Alarms indicates that the system is overloaded and risks resetting itself. If this error should occur, please report it to Secutron’s Technical Support Department.