Administration Methods
Print Server User Manual Windows 28
The following commands are supported:
The following applies for the instructions:
• not case-sensitive
• one or more space characters are allowed
• max. length is 128 byte
• only the ASCII format can be read.
Commands Option Description
<Command> get statuspage
get servicepage
get parameters
get jobhistory
get pagecounter
sends the status page of the print server
sends the service page of the print server
sends the parameter list of the print server
sends the job history
sends the number of printed pages
set parameters sends parameters to the print server
The syntax and values can be obtained from
the parameter list, see: 162.
Parameter and value must be entered into the
email body; see: 27.
print
printa
print
attachment
Prints the email (text only).
Prints the first attachment of an email.
See: 'printa'
update ps Carries out an automatic update using the
software that is attached to the email.
clean mailqueue Empties the email printer queue and deletes
all entries from the mailbox.
[<Port>]
(optional)
Default: LP1
LP1
LP2
LP3
LP4
LP5
Defines the port used by print server models
with several physical ports for sending data. If
no port was defined, the default value 'LP1'
will be used.
- LPT1 or USB1
- LPT2 or USB2
- LPT3 or USB3 (connected via USB hub)
- COM1 or USB4 (connected via USB hub)
- USB5 (connected via USB hub)
[ack]
(optional)
– sends an acknowledgment back to the sender
[<Comment>]
(optional)
– Freely definable text for descriptions.
To Next Page
Loading...
