SEH PS Series - Page 50

Network Settings
Print Server User Manual Windows 45
Configuring POP3 via the InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 15.
 The print server is set up as user with its own email address on a
POP3 server.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Double-click the print server in the device list.
The Properties dialog appears.
3. Select Configuration - Mail - POP3.
4. Configure the POP3 parameters; see: Table 7 44 .
5. Click OK to confirm.
 The settings are saved.
Configuring SMTP via the Printserver Homepage konfigurieren
Requirements
 The print server is set up as user with its own email address on a
POP3 server.
Proceed as follows:
1. Start the Print Server Homepage.
2. Select Configuration - Mail - SMTP.
Server port Defines the port used by the print server for receiving
emails. The port number 110 is preset. When using
SSL/TLS, enter 995 as port number.
Password Defines the password used by the print server to log
on to the POP3 server.
Delete read messages Enables/disables the automatic deletion of read
emails.
Ignore mail exceeding Defines the maximum email size (in KByte) to be
accepted by the print server.
(0 = unlimited)
Parameters Description