SEH PS Series - Page 89

Printer Status and Printer Messages
Print Server User Manual Windows 84
Table 13: Parameters for SNMP Trap Notification
* In the case of print servers with several physical printer ports, you must select the
relevant port.
Configuring SMTP Notifications via the InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 15.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Double-click the print server or printer in the device list.
The Properties dialog appears.
3. Select Configuration – Notification.
4. Select SNMP Trap Notification.
5. Select the tab of the relevant recipient.
6. Configure the notification parameters; see: Table 13 84 .
7. Click OK to confirm.
 The settings are saved.
Parameters Description
IP address Defines the IP address of the recipient.
Trap community Defines the trap community of the recipient.
Authentication traps Enables/disables the sending of authentication traps.
Printer traps Enables/disables the sending of traps in case of an
error.
Printer error* -
Paper empty, Paper jam, etc.
Defines the printer errors that will cause a
notification.