SEH PS Series - Page 96

Security
Print Server User Manual Windows 91
To enable the 'IP Sender Control', you must enter the IP addresses or
host names of the clients into an IP sender list. The print server will
only accept print jobs from clients specified in the list.
Up to eight IP senders can be specified. The use of wildcards (*)
allows you to define subnetworks (e.g. 192.168.122.*) and to autho-
rize these subnetworks for printing.
In order to disable the IP sender control you must enter '*' into
the first IP sender box. Once an IP sender has been defined, all
undefined clients lose their authorization to print via the print
server.
What do you want
to do?
 ’Assigning Authorizations via thePrint Derver Homepage’ 91
 ’Defining a Timeout via the InterCon-NetTool’ 91
Assigning Authorizations via thePrint Derver Homepage
Proceed as follows:
1. Start the Print Server Homepage.
2. Select Configuration - Protection.
3. Into the IP sender box, enter the IP addresses or host names of
authorized clients.
(The host name can only be used if a DNS server was configured beforehand.)
4. Click Save to confirm.
 The settings are saved.
Defining a Timeout via the InterCon-NetTool
Requirements
 The InterCon-NetTool is installed on the client, see: 15.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Double-click the print server in the device list.
The Properties dialog appears.
3. Select Configuration – Protection from the navigation bar.