Sekonic C-7000 SDK - SDK Instructions and Functions; Core SDK Functions

C-7000 SDK REFERENCE MANUAL
No. I401-C-700-034
Page 6
2012/03/01
Connect with C-7000
SK_Connect ()
Get Device Information
SK_GetDeviceInfor ()
Initializing
Yes
Remote Mode ON
SK_SetRemoteMode ()
Get Measurement
Configuration
SK_GetMeasConfig ()
Remote Mode OFF
SK_SetRemoteMode ()
No
Start processing
Start measuremen
SK_StartMeasuring ()
Get Device Information
SK_GetDeviceInfor ()
Measuring
Yes
No
測定条件設定
SK_GetMeasConfig ()
Get measured value
SK_GetMeasuringResult ()
Set Measurement
Configuration
SK_SetMeasConfig ()
Measurement processing
Disconnect with C-7000
SK_Disconnect()
End processing
3. Instructions
3.1. Namespace to use
C-7000 SDK uses "C7000 " as the namespace.
3.2. Class name
Class
Content
SDK
C-7000 SDK Body
3.3. Function
Function
Content
SK_Connect ()
Connect with C-7000
SK_Disconnect ()
Disconnect with C-7000
SK_GetDeviceInfo ()
Get device information
SK_SetRemoteMode ()
Set ON/OFF configuration of remote mode
SK_GetMeasConfig ()
Get the configuration of measurement set in the device
SK_SetMeasConfig ()
Set the configuration of measurement on the device
SK_StartMeasuring ()
Start measurement
SK_StopStandby ()
Stop standby mode of flash measurement
SK_GetMeasuringResult ()
Get the result of measurement
See basic flow of controlling C-7000 by using the SDK