Sekonic FLASHMATE L-308X - Shutter Speed Priority Mode

15
5. Measurement
●
NOTE
● Use Custom Setting to display shutter speed step increment in full,1/2 or 1/3 step
increment (
➡
P31).
● Shutter speed can be set from 60 sec. to 1/8000 sec.
● After the measurement, the aperture value will be automatically adjusted to maintain
proper exposure when changes in shutter speed and/or ISO are made.
● If “E.o” (over) or “E.u” (under) appears and blinks, the measurement cannot be made at
the selected settings (
➡
P29).
5-1-2 Aperture Priority Mode
Operation
1.
Press the MODE Button to select the
Aperture Priority Mode.
2.
Hold ISO Button and press UP or
DOWN Button to select the ISO
sensitivity ( ➡ P13).
3.
Press the UP Button or DOWN
Button to set the desired aperture.
4.
Press the MEASURING Button to
take a measurement. Measurements
will be taken continuously and
displayed as Shutter Speed as long
as the button is pressed. Releasing
the MEASURING Button will hold
and display the last measured value.
NOTE
● It is possible to switch between full, 1/2 or 1/3 F stop values with the custom setting
mode (
➡
P31).
● You can set aperture from 0.5
,
0.56
,
0.63
,
……4.0
,
4.5
,
4.8
,
5.0
,
5.6
,
6.3
,
6.7
,
7.1
,
8.0
,
9.0
,
9.5
,
10
,
11
,
13
,
14
,
16
,
18
,
19
,
20
,
22……64
,
72
,
76
,
81
,
90.
● If “E.o” (over) or “E.u” (under) appears and blinks, the measurement cannot be made at
the selected settings (
➡
P29).
M
O
D
E
MODE Button
ISO Button
UP Button
DOWN Button
1/10 shutter speed
Measured value
(shutter speed)
Set f stop value