Sekonic FLASHMATE L-308X - Cord Flash Mode

20
5. Measurement
●
5-1-5 Cord Flash Mode
In this Measuring Mode, a synchro cord (sold separately) is used to connect the ash to
the meter. Use this Cord Flash Mode when you need to ensure synchronization with the
ash or use a ash bulb. After pressing the Measuring Button, the meter trigger the ash
unit and displays F-stop value.
Operation
1.
Connect the ash synchro cord to the
synchro terminal on the light meter.
(Remove the Synchro Terminal Cap)
2.
Press MODE Button to select Cord
Flash Mode.
3.
Hold ISO Button and press UP or
DOWN B utton to select the ISO
sensitivity ( ➡ P13).
4.
Press the UP Button or the DOWN
Button to set the desired shutter
speed.
NOTICE
● Make sure that the settings are within the specications of the camera and ash system.
5.
Press the UP Button or the DOWN
Button to set the desired shutter
speed.
Press the MEASURING Button to
trigger the ash.
The measured value (f stop) will be
displayed.
M
O
D
E
UP Button
DOWN Button
MODE Button
ISO Button
1/10 step measured
value (f stop)
Set shutter
speed
Measured
value (f stop)