19
5. Measurement
●
5.
Fire the ash to take a measurement.
NOTE
● If the icon stops blinking before the ash res, repeat Steps 4 and 5.
NOTICE
In case of the following, please follow "Cord Flash Mode"(
➡ P20
).
● In mixed ash-ambient measurements, the meter may fail to detect the light if the ash
brightness is 9EV lower than the ambient light.
● Rapid start uorescent lamps and special lighting are sometimes mistaken for ash and
accidentally measured.
● Even if the ash is not red, when a sudden light change occurs in the light receptor,
measurement may be made.
NOTE
● Use Custom Setting to display shutter speed values in full, 1/2 or 1/3 values (
➡ P31
).
● Shutter speed can be set from 1 sec. through to 1/500 sec. Special shutter speed
settings will appear above 1/500 sec. (1/75, 1/80, 1/90 and 1/100 sec.)
● The displayed aperture value will be cancelled if the shutter speed is changed after a
cord measurement is taken. In such cases please measure again.
● After measuring, If the ISO is changed, the corresponding measured value (f stop value)
will be displayed.
● If “E.o”(over) or “E.u” (under) appears and blinks, the measurement cannot be made at
the selected settings (
➡ P29
).
To Next Page
Loading...
