Sena Tufftalk Lite - Headset Configuration Settings

31
English
Tufftalk Lite
13 HEADSET CONFIGURATION SETTINGS
You can set the conguration of the Tufftalk Lite by the voice menu
instruction described below.
1. To enter into voice conguration menu, press and hold the Center
Button for 10 seconds until you hear high-toned double beeps.
You will also hear a voice prompt, “Conguration menu”.
2. Tap the (+) Button or the (-) Button to navigate between the
menus. You will hear voice prompts for each menu item as below.
3. You can enable/disable a feature or execute a command by
tapping the Center Button.
4. If no button is pressed within 10 seconds, the Tufftalk Lite will exit
the conguration and go back to stand-by mode.
5. If you want to exit the conguration immediately, tap the (+)
Button or the (-) Button until you hear a voice prompt, “Exit
conguration”, and tap the Center Button.
The voice prompt for each menu item is as below:
(1) Phone pairing (5) Delete all pairings
(2) Second mobile phone pairing (6) Universal intercom pairing
(3) Phone selective pairing (7) Factory reset
(4) Media selective pairing (8) Exit conguration
(-) Button
or
(+) Button
Tap
Phone pairing
Second mobile phone pairing
Phone selective pairing
Media selective pairing
Delete all pairings
Universal intercom pairing
Factory reset
Exit configuration