Sencore S8100 - Before Start-Up; When Starting; During Work

3.7 Before Start-Up
3.8 When Starting
3.9 During Work
Before start-up, check the entire power tool for operationally safe conditions. In addition to the notes in the operating
and maintenance notes ( chap. 8, page 27), check the following items:
• Stop dial and one-touch stop button must be easy to operate.
• The throttle control must move freely and return automatically to the idle position. It must not be possible to operate
the throttle control without pushing (unlocking) the throttle control lock (throttle control locked).
•Thecutoffwheelmustbeattachedrmlytothespindle.
•Dangerofre!Ignitioncableandsparkplugconnectormustbermlyinplace.Looseconnectioncanresultin 
sparks which could ignite any escaping fuel/air mixture!
• In case of irregularities, visible damage, improper settings or limited function, the power tool must not be started. In
such cases, have the power tool inspected by specialist workshops authorized by us.
• Only use the power tool if it is in completely assembled condition.
• Keep at least 3 meters [approx. 10 feet] distance from the fueling site when starting.
Never start the power tool in closed rooms.
•Holdthetoolsecurelyandrmlywhenstarting.
Always start up on level ground and securely hold the power tool.
• Perform the starting process as described in chap. 6 on page 22.
• Check the idle setting after starting. The cut off wheel must not rotate in idle mode.
In addition to the safety provisions already listed, the following safety provisions also apply when working with the motor
device:
• Danger of poisoning! Once the engine is running, the power tool produces toxic exhaust that may be invisible and
odorless. Never start the power tool in closed rooms. Special danger also applies in narrow situations, troughs or ditches.
Onlyworkherewhenitisabsolutelycertainthatthereissufcientairexchangeandthatnotoxicgasesmayaccumulate.
•Increaseddangerofre!Donotsmokeattheworkplace–notevenintheproximityofthepowertool.
• Secure the workplace against accidental access by third parties, e.g. with warning signs. Only persons involved and
wearing adequate protective equipment and clothes must be present within 30 meters [approx. 30 yards] around the
working area.
• Check the site of deployment for possible dangers.
– Spark formation during cutting means that work must never be performed close to potentially explosive gases of
liquids,oreasilyammableobjects.
–Noelectricallines,waterorgaspipesorammablesubstancesmustbeplacedintheareatobecut.
–Objectsthatmayfalloffortoppleoverduringworkmustbesecuredorremovedfromtheworkingenvironmentrst.
– Prepare the workplace so that secure operator mobility is possible.
• The work piece to be cut must be free of foreign bodies such as screws, nails or stones.
• When working in residential areas, observe the noise protection provisions.
• Work carefully, considerately and calmly and do not endanger others.
– Ensure good sight and light conditions.
–Alwaysremainwithincallingdistanceofotherpersonswhomayadministerrstaidinemergencies.
– Schedule work breaks.
10 SENCORE S8100 CUT-OFF SAW MANUAL