Sencore S8100 User Manual

5.2 Installing Cut-Off Wheel with 1” Arbor
Thecutoffwheelsusedmustcorrespondtothespecicationsfromchap.7.1onpage25!
The power tool spindle is designed for cut off wheels with an arbor of 20 mm.
Cut off wheels with 1” arbor must only be installed together with the spindle adapter disk. Installation of cut off
wheels with 1” arbor:  Chap. 5.2, page 17!
When using cut off wheels with an arbor of 20 mm, no additional spindle adapter disk is required.
• Installation of cut off wheels with 1” arbor takes place
according to chap. 5.1 as of page 16.
• After applying the cut off wheel on the spindle,
however, the spindle adapter disk (e) must be put on
the spindle (f) additionally.
• Put the spindle adapter disk (e) onto the spindle so
that it inserts between spindle and inner bore of the cut
off wheel.
The support area of the spindle adapter disk must point
outwards in the installed condition, i.e. away from the
spindle.
The correct orientation of the spindle adapter disk is
mandatory to directly connect the plane inner area to
oftheoutermountingangetothecutoffwheel.Only
this warrants secure attachment of the cut off wheel.
• Application of the outer mounting ange and all
following steps must be performed again according to
chap. 5.1.
5.3 Removing The Cut-Off Wheel
• For cut off wheel removal, the power tool must be put securely on the ground. Securely hold the power tool at the top
handlewiththelefthandandpushitrmlyontotheground. Chap. 5.4, page 18
• Insert blocking pin (a) entirely into the cut off wheel blocking opening (12) to block the spindle.
Unscrew cut off wheel attachment screw (11).
Removewheel(b)andoutermountingange(c)(alsoseechap.5.1).
• Remove cut off wheel from the spindle. For cut off wheels with a 1” arbor, the spindle adapter disk also must be
removed from the spindle.
•Puttheoutermountingangebackontothespindlesothatthecurvedsidepointsoutward.
• Put on wheel (b) and turn in the cut off wheel attachment screw (11) again.  Chap. 5.1.
•Insertblockingpin(a)entirelyintotheblockingopening(12)andrmlytighten(30Nm[22.1ft·lbf])thecutoffwheel
attachment screw (11) again.
Securelyholdthepowertoolatthetophandlewithonehandandpushitrmlyontotheground.
• Remove the blocking pin (a).
f
e
Ask your Dealer FOR High quality
Sencore Blades for optimal performance
SENCORE S8100 CUT-OFF SAW MANUAL 17

Sencore S8100 Specifications

General

Brand	Sencore
Model	S8100
Category	Saw
Language	English