Sencore S8100 User Manual

5.4 Adjusting The Wheel Guard
The wheel guard (2) can be rotated forward and
backward in a limited area.
For adjustment of the wheel guard, the power tool must
in the off position and the cutting wheel must be stopped
from rotation. Put the power tool securely on the ground.
Securely hold the power tool at the top handle (4) with
thelefthandandpushitrmlyontotheground.Withthe
right hand at the handle for wheel guard adjustment (3),
rotate the wheel guard accordingly.
To keep sparks and particles away from the user, the
wheel guard always must be rotated forward as far as
the working situation permits.
If the separating device has been installed in the outer position, ensure when adjusting the wheel guard that the
water supply line is not clamped and that contact between the cut off wheel and water supply line in operation
is excluded.
5.5 Fueling Up
Danger to health!
Direct skin contact with gasoline and breathing in of gasoline fumes must be avioded.
Model S8100 with Auto Lube
TM
.
Fuel tank (18) for lead-free midgrade gasoline or
lead-free premium gasoline with a minimum pump
octane number of 89 (R+M)/2.
Donotllanypre-mixedfuelintothefueltank(18)!
Oil tank (19, green cap) for branded 2 stroke engine
oil corresponding to the standard ISO L EGD or
JASO FD.
Recommendation:
Use the “Sencore high performance semi-synthetic
2 stroke engine oil”
If there is not enough oil in the oil tank, the power
tool will automatically run at idle speed and will not
reach the speed required for work, which will be
noticed by changed noise generation as compared
to regular operation.
Atthispointatthelatest,oilmustberelled.
TheS8100isequippedwithafueltankandanoiltankeachthatmustbelledaccordingtothespecicationbelow
The fuel mix is automatically formed during operation in these models (separate lubrication, AutoLube
TM
, Automatic
Lubrication).
Fill in operating media (gasoline and oil)
Observe the safety provisions when fueling up. Fuel up only with the motor switched off.
•Cleanthell-inareawell.
• Lay the saw on it’s side so that the fuel tank cap points up.
• Unscrew the tank cap.
4
3
2
19
18
18 SENCORE S8100 CUT-OFF SAW MANUAL

Sencore S8100 Specifications

General

Brand	Sencore
Model	S8100
Category	Saw
Language	English