6.2 Start-Up Position
6.3 Switching On The Engine
6.4 Switching Off The Engine
• Put one foot on the rear handle (6) to support the power
toolagainsttheoor.
• Securely hold the power tool at the top handle (4) with
onehandandpushitrmlyontotheground.
• Operate the starter handle with the other hand (16).
Other start-up positions are not permissible!
• Initially pull out the starter handle (16) slowly until
resistance can be felt for start-up (upper dead point of the
piston).
• Then quickly and strongly pull through the starter
handle.
• Always pull out the rope straight.
• Do not let the rope scrape across the rope eyelet edge
(a).
• Danger of breaking rope!
Do not pull out the rope to the stop.
• Always return the starter handle to its initial position – do
not let it snap back.
Damaged starter ropes can be replaced by specialist
workshops authorized by us.
Avoid any contact between the cut off wheel and body parts or objects.
The following notes serve to increase the service life of the starter mechanism:
Ensure that the cut off wheel has stopped before putting down the power tool.
Release the throttle control and push the one-touch stop button.
Recommendation: Turn the stop dial to “0” only for maintenance work to prevent accidental start-up of the engine.
When operating the power tool, always push the one-touch stop button to switch off the engine.
16
6
4
a
16
SENCORE S8100 CUT-OFF SAW MANUAL 23
To Next Page
Loading...
General