Sencore S8100 User Manual

Install handle for wheel guard adjustment and cut off wheel again
• Install the handle for wheel guard adjustment (3) again to the wheel guard with the respective attachment screws.
• Install the cut off wheel:  Chap. 5.1, page 16
5.9 Initial Starting | Running Behavior
After production, the power tool is subjected to an inspection and test process that ensures that the motor is then run in
perfectly.
Therefore, no special measures are required for initial start-up.
6 Starting up and switching off the engine
6.1 Starting Up Process
Starting preparations
•
Putthepowertoollevelandfreefromobstaclesontheatoorandobservethatthecutoffwheeldoesnottouchany objects.
• Put the wheel guard into the best position for the planned use.  Chap. 5.4, page 18
Automatic mixture control for cold and warm start
The power tool has an electronically controlled carburetor. Therefore, no special settings are required for cold or warm
start (e.g. manual operation of a choke).
Starting Notes
• Turn the stop dial to the operating position “1”.
•Beforetherststart,operatetheprimer. Chap. 4.5, page 14
• Before starting-up, push the decompression valve.  Chap. 4.5, page 14
• Put the power tool in start-up position.  Chap. 6.2, page 23
• Pull on the starter handle.  Chap. 6.3, page 23
OBSERVE SAFETY PRECAUTIONS!!!
22 SENCORE S8100 CUT-OFF SAW MANUAL

Sencore S8100 Specifications

General

Brand	Sencore
Model	S8100
Category	Saw
Language	English