Sencore S8100 - 7 Power Tool Use

7 Starting up and switching off the engine
Always observe all safety notes and all other information in all chapters of these operating instructions for any work!
Check list for use (keywords only!) ............................................................. 
• Before start-up:
– Power tool in an operationally safe condition! ............................. Operating instructions complete
– Prescribed work clothes ............................ ................................. Chap. 3.3, page 8
– Working area inspected and secured .........................................  Chap. 3.2, page 7, and
chap. 3.9, page 10
 –Correctcutoffwheelrmlyinstalled........................................... Chap. 5.1, page 16, and
chap. 7.1, page 25
– Wheel guard in best position ....................................................... Chap. 5.4, page 18
– Cutting device position, preferably center position......................  Chap. 5.8, page 20
– Ribbed belt tension correct .........................................................  Chap. 5.6, page 19
– Tool properly fueled ....................................................................  Chap. 5.5, page 18
• Starting: ...................................................................................................  Chap. 6 complete, as of page 22
– Starting preparations ..................................................................  Chap. 6.1, page 22
 ○Stopdialinoperatingposition............................................... Chap. 6.1, page 22
• During work – generally safe work: .........................................................  Operating instructions complete
– Check idle settings .....................................................................  Chap. 8.3, page 28
– Inspecting the working situation..................................................  Chap. 3.9, page 10, Chap. 7.2,
page 25, and Chap. 7.3, page 26
– Wet cutting preferred ..................................................................  Chap. 5.7, page 19
– Secure working technique...........................................................  Chap. 7.3, page 26, chap. 7.4,
page 26, and chap. 7.5, page 26
– Operating and maintenance notes complete...............................  Chap. 8 complete, as of page 27
 ○Airlterclean......................................................................... Chap. 8.4, page 29
• After work:................................................................................................  Operating instructions complete
– Cleaning and care.......................................................................  Chap. 8.1, page 27
– Secure storage of power tool......................................................  Chap. 8.10, page 35
– Maintenance ...............................................................................  Operating instructions complete
.
24 SENCORE S8100 CUT-OFF SAW MANUAL