8.10 Shutting down and storage
Before shutting down and storage, the power tool must be cleaned thoroughly and checked for damage.
Cleaning and care: Chap. 8.1, page 27
Onlystorethepowertoolindryrooms.Theremustnotbeanyopensourcesofreorthelikenearby.Preventunauthorized
use – in particular by children.
Before extended storage (> 4 weeks), additionally empty the tanks for operating materials in a well-ventilated location
and clean them. Start engine with the fuel tank empty and empty the carburetor until the engine goes out. Oil residue
fromthefuellubricationmayotherwiseclosethecarburetornozzlesandmakestart-upmoredifcultlater.
9 Warranty
We warrant perfect quality and assume the costs for any subsequent improvement by replacement of defective parts in
case of material or production errors that occur during the warranty period after the day of sale.
Pleaseobservethatspecicwarrantyconditionsapplyinsomecountries.Indoubt,askyourvendor.
Please understand that we cannot assume any warranty for the following damage causes:
• Failure to follow the operating instructions.
• Failure to perform required maintenance and cleaning.
• Damage due to improper carburetor settings.
• Normal wear and tear.
• Obvious overload.
• Use of other than approved working tools.
• Application of force, improper treatment, misuse, abuse or accident.
• Overheating damage due to contamination of the fan housing.
• Repair by unauthorized personnel.
• Use of unapproved replacement parts or other than original parts if they caused the damage.
• Use of unsuitable or outdated operating materials.
• Damage due to the usage conditions from renting.
Cleaning, care and adjustment work are not deemed warranty services.
Warranty services must be completed at an authorized service center only.
10 Wear Parts
Several components are subject to wear in operation or regular wear and may have to be replaced in time.
The following wear parts are not subject to the manufacturer’s warranty:
11 Wear Parts
11.1 Your Warranty Rights and Obligation
The EPA (The US Environmental Protection Agency) and Sencore, are pleased to explain the emissions control system
warranty on your 2013 and later small nonroad engine. In the U.S. all new small nonroad engines must be designed,
built, and equipped at the time of sale to meet the U.S. EPA regulations for small nonroad engines. The engine must be
free from defects in materials and workmanship which would cause it to fail to conform with U.S. EPA regulations and
standardsforthersttwo(2)yearsofusefromthedateofsaletotheultimatepurchases.Sencoremustwarrantthe
• Operating materials
•Airlter
•Fuellter
• Clutch
• Spark plug
• Starting device
• Cut off wheel
• Belt
SENCORE S8100 CUT-OFF SAW MANUAL 35