Using the “Conference Manager” software
200 | ADN Digital Conference System
Setting the volume and the tone color
of the floor channel
To set the floor channel volume:
왘 In the “Floor” area, move the “Volume” slider
– u
pwards to increase the floor channel volume or
– downwards to reduce the floor channel volume.
The floor channel volume is changed immediately. The numeric value set is dis-
played below the slider.
To set the tone color of the floor channel:
왘 In the “Floor” area, move the “EQ low”, “EQ mid” or “EQ high” sliders to change
the tone co
lor.
왘 Click “OK”.
Your settings are
saved and the “Audio Settings” window closes.
CAUTION
Danger of hearing damage due to loud hissing!
When the floor cha
nnel volume is set to a high level or when several
participants speak simultaneously, feedback (loud hissing noise) can
occur. This can cause hearing damage.
왘 Reduce the floor channel volume (see page 200 or page 214).
왘 Activate the “Feedback Suppression” function to be able to
in
crease the volume before feedback can occur (see page 99 or
page 202).
왘 Make sure that the “Audio Gain Reduction” function is activated
(see page 201).
This function reduces the gain per active microphone by the
selected level and thus prevents feedback.
왘 Increase the distance between the indi
vidual conference units to
at least 50 cm.
To Next Page
Loading...
