EM-XSW 1 DUAL rack receiver
52
Adjusting the volume of the audio outputs
Use the VOL+/VOL- buttons to set the level of the audio signal
coming from the receiver’s audio outputs (Balanced/Unbal-
anced). This audio signal can be output to a mixing console or
an amplifier, for example.
▷ Press the VOL+/VOL- buttons to adjust the volume.
►
▷ Make sure that the signal in the next device in the signal
chain (e.g. mixing console, power amplifier, guitar amplifi-
er, etc.) is not overdriven.
To Next Page
Loading...
