Sennheiser XS WIRELESS 2 - Establishing a Radio Link | Synchronizing the Receiver and Transmitter

Establishing a radio link | Synchronizing the receiver and transmitter
90
Establishing a radio link | Synchronizing
the receiver and transmitter
Conditions and restrictions for using frequencies
There may be special conditions and restrictions for us-
ing frequencies in your country.
Before putting the product into operation, find the information
for your country at the following address:
www.sennheiser.com/sifa
To establish a radio link between the transmitter and receiver,
we recommend the following procedure.
To successfully pair a receiver and a transmitter, both
devices must have the same frequency range.
Step 1: Set a free frequency on the receiver
We recommend using the AUTO SCAN function, as this is the
most reliable way to identify free frequencies (EM-XSW 1:
„Setting the frequency automatically (AUTO SCAN)“ | EM-
XSW 1 DUAL: „Setting the frequency automatically (AUTO
SCAN)“ | EM-XSW 2: „SCAN menu item“).
If you know free frequencies in your area, you can also set the
frequency manually (EM-XSW 1: „Setting the frequency manu-
ally“ | EM-XSW 1 DUAL: „Setting the frequency manually“ |
EM-XSW 2: „PRESET menu item“ or „TUNE menu item“).
Step 2: Synchronize the receiver and transmitter
▷ Press and hold the SYNC button on the transmitter.
The LED flashes alternately red and green.
▷ While the LED is flashing, short-press the SYNC button on
the receiver.
The transmitter and receiver are synchronized and the con-
nection is established.