Sensaphone 400 - Page 93

Chapter 6: Acknowledgment, Status Report & Remote Access
91
Many of the commands use three letters that represent an abbreviation of
the selected command. For example, to Set a High limit on Zone 1 you
would press S + H + 1 (or in numeric form 7 + 4 + 1)
The tables below list all of the touch-tone commands that are supported.
Commands are listed in both character and numeric formats. The # key is
used as an ENTER key. Use the * key to represent a negative sign or to rep-
resent the [CODE] key when programming telephone numbers.
Enable/Disable Zones
This command will toggle the selected zone between the enabled or dis-
abled state.
Description Touch-Tone Command
Enable/Disable Zone * + Z(9) + (zone number)
Set and Recite High & Low Alarm Limits
The following commands are used to set or recite the Low Alarm Limit for
any Zone.
Description Touch-Tone Command
Set Zone Low Limit S(7) + L(5) + (zone #) + (value) + #
Description Touch-Tone Command
What Is Zone Low Limit W(9) + L(5) + (zone #)
The following commands are used to set or recite the High Alarm Limit for
any Zone.
Description Touch-Tone Command
Set Zone High Limit S(7) + H(4) + (zone #) + (value)+ #
Description Touch-Tone Command
What Is Zone High Limit W(9) + H(4) + (zone #)
Set and Recite Telephone Numbers
The following commands will allow you to program and recite dialout tele-
phone numbers. You may need to use the Special Dialing Codes below.
Special Dialing Codes Summary
Code 1: Numeric pager type
Code 2: Wait for answer
Code 3: Change to Touch-Tone