Sensaphone 400 - Page 94

92
SENSAPHONE 400 User’s Manual
Code 4: Pause
Code 5: Star (*)
Code 6: Pound (#)
Description Touch-Tone Command
Setting a phone number S(7) + T(8) + (entry 1–4) + (telephone num-
ber) + #
Description Touch-Tone Command
Reciting a phone number W(9) + T(8) + (entry 1–4)
Record and Play Custom Voice Messages
The following commands will allow you to record and play back custom
voice messages for the ID message (0) and each zone (1–4).
Description Touch-Tone Command
Record a Message S(7) + M(6) + (entry 0–4)
Description Touch-Tone Command
Play a Message W(9) + M(6) + (entry 0–4)
Control the Relay Output
The following commands will allow you to check the status of the relay out-
put and to toggle the Relay Output On and Off.
Description Touch-Tone Command
Reciting the Output Status W(9) + R(7) + O(6)
Description Touch-Tone Command
Switching the Output S(7) + R(7) + O(6)
Activate Microphone Listen-in
The following command will allow you to activate the microphone listen-in
for the programmed duration.
Description Touch-Tone Command
Activate Mic Listen-in M(6) + I(4) + C(2)