PRODUCT INSTRUCTION MANUAL
Page 14 of 29
Part 7 Settings (cont.)
7.5 Standby Mode
To select manual operation for going back to measurement mode or to select auto return to measurement
mode.
Enter
Mode
OR
To select auto return to measurement
mode-- after 3 minutes it will auto return
to the measurement mode if no keys are
touched in setup or calibration mode.
GO TO "HI POINT ALARM SETUP,
SECTION 7.6
To manually return to
measurement mode
(stand by function ON),
press "SETUP" key to leave
setup menu and return to
measurement mode.
Setup
FIG 7-4
Form: INSTRTX3000-Rev A
To Next Page
Loading...
