Sentec LuMon System

To Previous Page

for the LuMon System

93 of 93

PLEASE CONTACT US, IF YOU HAVE ANY

QUESTIONS!

Manufacturer:

Phone: +41(0)81 330 09 70 | Fax: +41(0)81 330 09 71 | info-eit@Sentec.com

Main Page

Table of Contents3
Introduction5
Lumon System5
Symbols, Terminology and Abbreviations6
Safety Information7
Safety Symbols and Messages7
Warnings and Cautions7
EMC-Related Safety Information11
Glossary of Symbols12
Indications and Contraindications14
Intended User14
Intended Use: General14
Intended Use: Indications for Use14
Contraindications14
Principle of Operation and Limitations15
General Principle of Operation15
Principle of Operations When Used for Lung Function Monitoring15
Particular Features of Sentec Eit16
Limitations of Eit/Sentec Eit16
System Overview18
Lumon Monitor18
Belt Connectors19
Belts20
Contact Agent/Spray21
Measuring Tapes22
Lumon Monitor Gui24
Gui Overview and Navigation24
Scoutview27
Lufuview29
Ventview33
Common Aspects of Eit Images and Trends34
Visual Indicators36
Operator-Adjustable Parameters40
Installation and Preoperational Check42
Using the Equipotentiality Terminal Connector42
Power Supply42
Switching the Lumon Monitor on and Checking Its System Settings43
Preoperational Check43
Minimum Requirements44
Belt Application and Initiating Monitoring45
Sensorbelt Application and Initiating Monitoring for Adults and Children45
Lumon Belt Adult Application and Initiating Monitoring for Adults and Children47
Lumon Belt Neo Application and Initiating Monitoring for Neonates and Infants49
Checking the Proper Setup51
Checking the Adequacy of the Selected Analysis Mode55
While Monitoring the Patient58
Selection of Patient-Specific, CT-Derived Thorax and Lung Models58
Accounting for the Patient S Position59
Quality of Calculated Eit Data60
Global Dynamic Images and Plethysmogram61
Breath Detection63
Respiratory Rate64
Analysis Modes64
Trends of Eeli, Eili and Aeration66
Stretch Image Relative Tidal Stretch67
Center of Ventilation, Silent Spaces and Functional Lung Spaces69
Operator Events and Screenshots70
Recording or Exporting Data71
Pausing or Ending Monitoring73
Pausing Monitoring Without Belt Removal73
Pausing Monitoring with Belt Removal And/Or Replacement73
Ending Monitoring73
Maintenance74
Routine Checks, Preventive Maintenance and Safety Checks74
Cleaning and Disinfection74
Replacing the Fuses of the Lumon Monitor76
Disposal of Parts of or Removed from the Lumon System76
Instructions for Repacking and Shipping76
Troubleshooting77
Technical Specifications78
System Performance78
System Characteristics, Compliance and Compatibilities78
Lumon Monitor80
Belt Connectors81
Belts82
Contact Agent82
Device Classification82
Emc Declaration83
Annex85
LMS Related Accessories, Key Spare Parts and Documents85
Terminology85
Abbreviations Used in this User S Guide90
References92

Sentec LuMon System - Page 93

Table of Contents

Related product manuals