Note: Your radio must be powered on and have sufficient battery charge
for the duration of the customisation process.
To program a single radio
A data/programming cable, with either an RS232 (D-type) connector or a USB
connector, is available from Sepura for customising a single radio.
1. Connect the USBprogramming cable to the computer.
2.
Connect the cable to the radio by inserting the hook on the connector into
the slot as shown.
3.
Secure the cable in position. Do not over tighten.
4. When programming is complete disconnect the cable from the radio.
User Guide
139
To Next Page
Loading...
