View and edit scan list
1. Select Menu > Groups > Scan Lists.
2. Use the Up and Down navigation keys to select one of the UDSLs and
press Open.
3. Press Edit.
Change default (selected) talkgroup
1. Use the Up and Down navigation keys to select one of the talkgroups in
the UDSL.
2. Select Edit > Options > Select.
3. Select Edit > Options > Save.
Add a talkgroup
1. Press Options > Add.
2. The talkgroup selection box is activated. Select a talkgroup as described in
Select a talkgroup (described on page 49) then press Select.
3. Select Edit > Options > Save.
Remove a talkgroup
Select the talkgroup you wish to remove then:
1. Select Edit > Options > Delete.
2. Select Edit > Options > Save.
Changing group scanning priority
1. Select Edit > Options > Change Priority.
2. Select scan priority (High), (Normal) or (Low) then press Select.
3. Select Edit > Options > Save.
Scanning ON/OFF
You can enable or disable scanning of talkgroups in the selected UDSL. (Note:
the selected talkgroup is always scanned.)
1. Select Menu > Groups > Scanning ON/OFF.
2. Press Toggle (or the Select/Send key) to enable/disable scanning:
Scanning enabled—UDSL talkgroups are scanned. The Scanning icon
is displayed.
Scanning disabled—UDSL talkgroups are not scanned.
User Guide
53
To Next Page
Loading...
Need help?
General
