Belt Clip
The belt clip (part no. 300-01923) is used to attach the radio to your belt. The clip is fitted to the
mounting clip attachment points on the back of the radio.
You do not have to remove the clip before charging the battery. The radio can be inserted into any of
the SC21 battery chargers with the battery and belt clip attached.
Attaching the belt clip
Caution! Risk of damage to the radio. Ensure the belt clip screws are secure, but do not
over tighten. If using a torque screwdriver, apply a maximum torque of 45 Ncm or equivalent.
1. Using a PZ 1 screwdriver attach the belt clip to the two attachment points as shown.
MAX 45 Ncm
PZ1 x 2
Do not over tighten
Removing the belt clip
1. Using a PZ1 screwdriver remove the belt clip from the two attachment points.
User Guide 121
To Next Page
Loading...
