Sepura SC21 Series User Manual

Icon Description
User Profile
Appears when a user profile is activated. Your radio may be
programmed for a number of user profiles. The number next to the
icon indicates the chosen user profile.
Communication Type Mismatch
This icon appears when there is a mismatch in communications
and is activated when:
the radio is out of range of a gateway when another radio
within range of the gateway is in a group call, and you
cannot participate in the call. and that you cannot take part in
the call.
a radio out of range of the gateway is attempting to respond
to a group call, and the speech if not being routed using the
gateway to TMO users.
a radio within range of a DMORepeater cannot make a call
and attempts to set up a call in DMO instead, the icon
appears on all radios within the talkgroup to indicate that
there are members of the talkgroup who cannot take part in
the call.
Bluetooth® device connected
Appears when you have activated Bluetooth® and have
successfully connected a device.
Bluetooth® on, no device connected
Shows that you have activated Bluetooth® but do not have a
device connected.
Lone Worker protection enabled
Indicates that you have enabled the Lone Worker feature on your
radio.
Man Down motions and tilt sensors active
You have enabled the Man Down feature and the motion and tilt
sensors are active.
Man Down Tilt sensor active
You have enable the Man Down feature, but only the tilt sensor is
activated.
Man Down motion sensor active
You have enable the Man Down feature, but only the motion
sensor is activated.
GPS tracking enabled
Indicates that the GNSS (Global Navigation Satellite System)
function has been enabled.
GPS tracking not available
User Guide 13

Sepura SC21 Series Specifications

General

IP Rating	IP54
Operating Temperature	-20°C to +55°C
Channel Spacing	25 kHz
Ingress Protection	IP54
Channels	Up to 2000
Frequency Bands	380-430 MHz, 806-870 MHz
Battery Life	Up to 14 hours
RF Power Output	1W
TETRA Air Interface	ETSI EN 300 392-2