Sequential prophet 5 - R416 Voice Level.4-13; R303 Sequencer CV Offset.4-13

4-19 R416 VOICE LEVEL
As mentioned in para. 4-9. R416 can be used to isolate the voices. To set VOICE LEVELS at the end of
the trim procedure, start in BASIC TRIM SETUP. TABLE 4-0.
Switch off S221 UNISON. Turn all R416s fully clockwise. Play polyphonically to determine which voice
is softest, then turn the other four voices down to match. This can be done either by ear or with
instruments.
4-20 R303 SEQUENCER CV OFFSET
R303 should only be trimmed once the Prophet is determined to be in tune. It is set so the particular
sequence or other CV source being used does not detune VOICE 5.
i
4-13