SCORPIO 38’ - 45’ - MAINTENANCE & SERVICE - Maintenance Requirements
Version 1.02 May 27, 2022
SERVICEVISION BIS SL
Ríos Rosas, 20 · 08940 CORNELLA DE LLOBREGAT (Barcelona) Spain · Tel. 34 93 223 86 30 · Fax 34 93 223 86 31 67
comercial@servicevision.es · www.servicevision.es
6 MAINTENANCE & SERVICE
The Scorpio crane must be inspected periodically since the delivery date. The inspections must be
done by qualified personnel.
Each inspection will determinate the conditions of the equipment, and the parts or components that
need repair or replacement.
In case the user is not doing these inspections or is not following the recommendations of the
technical personnel of Servicevision, Servicevision will not be responsible of any damage generate
by the crane.
6.1 MAINTENANCE REQUIREMENTS
Any maintenance must be done only by personnel trained by
Servicevision. Servicevision will provide the certificate as Maintenance
technician.
The Maintenance technician will decide how often and the works to
do depending on the shooting conditions on the previous shooting and
the reports received from the operators and the technicians on
location.
6.2 GENERAL MAINTENANCE
For a proper and correct maintenance, the Scorpio crane must always be revised before and after
every shooting. The parts to be checked or changed will be under the maintenance technician
judgement. As well as the parts to be cleaned or lubricated since the conditions under the crane has
been exposed in the previous days can be different every time. The table below is only to be used as
a reference, depending on the shooting conditions the components to be check may change.
Before every shooting there are some parts to be checked or cleaned described in the chapter 3
Set up the equipment. Those checks need to be done before every shooting.
Note: Before any arm manipulation, the crane must be
disconnected from the power source and, unless it is
specified, strapped into the base.
To Next Page
Loading...
