SCORPIO 38’ - 45’ - SPECIAL CONFIGURATIONS - Record memories crane-head
Version 1.02 May 27, 2022
SERVICEVISION BIS SL
Ríos Rosas, 20 · 08940 CORNELLA DE LLOBREGAT (Barcelona) Spain · Tel. 34 93 223 86 30 · Fax 34 93 223 86 31 91
comercial@servicevision.es · www.servicevision.es
8.3.2 ANALOG TRIGGER
To start the memories of the head and the crane at the same time with
the analog hand command, the adaptor cable (Ref. 7082) needs to be
connected to the hand command. The 7pin female goes to the hand
command, the male can be extended with regular hand command
cables to the electronic box of the crane.
The Lemo 6 pin female needs to be extended with a male to male
cable (Fig. 08.31) into the analog trigger box. From the trigger box,
another male to male Lemo cable needs to be connected into the
head control in the JDR Roll connector in the back of the control.
With everything connected and the 8.3.1 Set up conditions fulfilled,
press the red button of the trigger and both memories will start at the
same time.
To play them back at the same time, use the same procedure but
instead of REC in the memory menu, set the axes in PLAY.
8.3.3 DIGITAL TRIGGER
To start the memories with the digital trigger memory the hand
command needs to be connected to the trigger with a regular hand
command cable. From the 7pin male panel connector of the digital
trigger memory another regular hand command cable needs to be
connected to the crane electronic box. The Lemo 6 pin female from
the trigger box needs to be connected to the JDR Roll connector in
the back of the control with an extension cable (fig. 08.31).
With everything connected and the 8.3.1 Set up conditions fulfilled,
press the green button of the hand command and both memories will
start at the same time. To play them back at the same time, use the
same procedure but instead of REC in the memory menu, set the axes
in PLAY.
To Next Page
Loading...
