10 Introduction • Super II
Understanding Your Scale
Keypad: Soft Keys
The Super II keypad is divided into three groups of keys. The first set of keys underneath the display are
referred to as “soft keys”. Their function changes depending on where you are in the counting procedure
or which level you enter in the menu.
The default soft keys are listed below and have the following functions:
ZERO Assigns the pan and whatever is currently being weighed a value of zero. While the
scale is determining a stable weight reading, the display will indicate “Zero Base
Process Activated”. A zeroing operation underway can be cancelled with a second pass of
the ZERO key.
Note: If a Tare value is stored in memory, it will be cleared.
SAMPLE Determines a stable reference point and displays the preprogrammed sample sizes
(10, 25, 50, 100 pieces). A SAMPLE size selection menu can be displayed if activiated in
the Supervisor setups (see SAMPLE soft key in the “Supervisor and Technical Setups
Manual”.
COUNT Instructs the scale to begin or resume counting.
PRINT Instructs the scale to print preprogrammed fields or label format. If multiple label
formats are active, a print menu is displayed in order to make a numeric
print register selection.
CLEAR Used to switch from Count (pieces) to Weight.
LRG SPL Used to go to the next programmed sample size. For example, to go from “ADD 10
PIECES” to “ADD 25 PIECES”.
UPDTAPW Used to recalulate the APW based on a larger sample size. The additional sample
weight cannot exceed 100% of the previous sample to avoid the compounding of
errors (see Counting with Accuracy Enhancements in this User Manual).
EXIT Returns the display to either Weight or Count(pieces) depending on which was last
active before the menu prompt.
To Next Page
Loading...
Need help?
General
