Super II • User Functions 31
Select Menu Option:
1000
ALARMS UNITS COUNTER SET UPS EXIT
OK!
Base 1
Pieces
MORE
abc reset
menu remote
tare
Soft Key:
ALARMS
Setting and Using Alarms
The Super II has three alarm outputs which can be used to signal when the measured weight or count is
within a pre-programmed range. To access the ALARMS soft key, be certain it has been enabled through
the SET PTS soft key of theTechnical setups menu (See “Supervisor and Technical Manual”). Then follow
the steps below:
1. Pr ess the menu hard key on the controller, and then the MORE soft key. The soft keys will change to:
2. Press the ALARMS soft key and the soft keys change to the following:
3. Press the START soft key to enable the alarm outputs to respond to the weight/count presently on the scale.
4. Pr ess the STOP soft key to freeze the alarm outputs in their present state.
5. Press the RESET soft key to change the alarm outputs to their zero weight/count state.
6. Press the SET PTS soft key to set the alarms and the soft keys change to the following:
LOW: 0.0 TARGET: 0.0 HIGH: 0.0
LOW TARGET HIGH % GO BACK
Weight: O . O
OK!
Enter Low, Target or High setpoint or
press % to enter deviation from target.
LOW: 0.0 TARGET: 0.0 HIGH: 0.0
ALARM1 ALARM2 ALARM3 Stopped
START STOP RESET SET PTS GO BACK
O.O
OK!
Grams