34 User Functions • Super II
Base 1
Pieces
Select Menu Option:
0.00
SET PTS UNITS COUNTER SET UPS EXIT
OK!
Base 1
Grams
MORE
abc reset
menu remote
tare
X UNIT Y UNIT GO BACK EXIT
Enter the desired X and Y limits
followed by the X and Y key.
X: 0 Y: 0
Soft Key:
COUNTER
Setting a Print Counter for Box Counting or Serial Number Generation
The scale has the capability of keeping track of a counter each time the PRINT key is used. This counter can
be used to generate sequential numbers for box or package labeling during kitting operations or to
generate a sequential serial number for a label.
To enter the beginning and ending values of a printing sequence, follow the steps below:
1. Press the menu hard key, followed by the MORE soft key. The soft keys change to the following:
2. Press the COUNTER soft key and the soft keys change to the following:
3. To enter values for the X unit and Y unit (X being the beginning number in the sequence and Y being the ending number),
type in the desired number using the numeric keypad followed by the appropriate soft key for the X or Y position. The X and Y
counters are limited to 10 numeric characters each.
4. To return to the default User Menu, press the EXIT soft key.
5. The X and Y values will remain in memory until X equals Y at which time they will reset to Ø. The counter can also be
deactivated by entering Ø for the X and Y values following steps 1 - 3 above.
NOTES:
a. You do not need to enter a value for X if 1 is the first value in your sequence.
b. Y must be greater than X.
c. You may not enter negative numbers.
To Next Page
Loading...
Need help?
General
