20 User Functions • Super II
Reverse Counting or Kitting
Use this feature to count the number of pieces removed from a full container. This is especially helpful
when kitting (counting out a certain number of pieces to be packed together). To perform reverse count-
ing or kitting, use the following procedure:
1. Place a container full of pieces you wish to count on the pan.
2. Press the ZERO key then press the SAMPLE key.
3. The scale display will read “ADD 10 Pieces”. (The sample size requirement can be increased by pressing the LRG SPL key
repeatedly. The predetermined sample sizes are: 10, 25, 50 and 100 pieces. This sequence of predetermined sample sizes will
repeat itself as the LRG SPL key is pressed.)
4. When you have selected the desired sample size, remove the indicated number of pieces from the container.
5. Press the COUNT key.
6. Remove pieces until the display shows the number of pieces you wish to count out or kit.
7. Press the ZERO key.
8. Repeat Steps 6 and 7 as many times as needed.
NOTE: a. If the average piece weight is known, you may press the — key, enter the average piece
weight, and press the APW key in place of Steps 2-5.
b. If the sample size is not large enough to satisfy the minimum accuracy requirement the
display will read “REMOVE nnn MORE”. Remove the specified number of pieces (i.e. nnn) from
the container, then press the COUNT key.
c. It is possible that the required sample size is larger than the quantity needed for each kit. For
instance, the required sample size is 100 pieces but only 50 pieces are to be kitted together. In
this case, follow steps 1 through 5 above, place the 100 piece sample back into the container
and press the ZERO key. Continue with steps 6 through 8 above.
To Next Page
Loading...
Need help?
General
