12 Introduction • Super II
LEDs
There are two LEDs on the keypad that are only active when the battery option is installed and in use.
low battery “red” Indicates that the battery needs to be charged.
charging “green” Indicates that the battery is being charged.
Display Symbols
OK Reading shown is stable.
ABC Alphanumeric keypad is in the letter entry mode.
------ The reading is outside the calibration range.
OL The ----- is indicating an overload situation.
UL The ----- reading is indicating an underload situation.
GROSS The weight displayed is the gross weight on the pan including any tare wieght.
Back of the Controller
There are five ports labelled on the bottom of the controller. Their functions are as follows:
BASE Port for connection to Setra base.
KEYBOARD Port for connection to optional computer PS2® style QWERTY keyboard(not available from
Setra). For CE compliance, Setra has certified the use of Behavior Tech Computer
Corporation’s Model BTC 5210 keyboard. Other manufacturer’s keyboards may or may not
affect the limitations set forth in CE certification. Setra cannot be responsible for other
manufacturer’s specifications.
BI Bi-directional RS232 communications port for connection to a computer. Default port
settings are 9600 baud, 8 data bits, no parity, 1 start, and 1 stop bit, hardware handshaking
on (RTS/RTC).
OUT RS232 output port for connection to a serial printer. Default port settings are 2400 baud, 8
data bits, no parity, 1 start, and 1 stop bit for the DYMOSetra Labelwriter 250 printer, no
hardware handshaking.
IN RS232 input port for connection to a bar code scanning device. +5V is supplied on pin 6.
Default port settings are 2400 baud, 8 data bits, no parity, 1 start, and 1 stop bit for Setra
Linear Imager Gun (403678) or Smart Wand (403676), no hardware handshaking.
®PS2 is a registered trademark of International Business Machines
To Next Page
Loading...
Need help?
General
