Super II • User Functions 25
SAVE GO BACK
PART ID: ABC-123
Press SAVE to record the following:
COUNT:1000 ON:12:00 1/01/00
When the ACCEPT key is pressed for an existing record where the count is being saved, the following soft keys appear
(see “Supervisor and Technical Setups” manual for DATBASE SETUP options).
ADD CT ADD CT will add the displayed Count to the Count register in the database.
SUB CT SUB CT will subtract the displayed Count from the Count register in the database.
UPD A/T UPD A/T will update the APW and/or Tare weight in the database.
UPD ALL UPD ALL will update all available fields in the database.
NOTE: A record cannot be saved to the Database without an identification number (PART ID ) for that
record.
Yo u can set up database security features that will prevent the changing, deleting, or addition of records to the database.
Please refer to the SECURTY soft key in the “Supervisor and Technical Setups” manual.
If you already know the information to be stored in the database, and do not need the scale to
develop the needed information (such as an APW), you can enter the record through the DATBASE soft key functions
described on the following pages.
b. Saving to the Transaction Log
When saving to the Transaction Log, the following screen will appear:
Press SAVE to confirm the recording of the listed transaction:
NOTE: The fields displayed for Transaction Log recording are selectable in the TRANSAC/SETUP menu in
the “Supervisor and Technical Setups” manual.
Transactions for non-scale counted parts can be recorded by manually entering the count in the Transaction Log Saving
Screen listed above.
If both the Database and the Transaction Log are turned on, the program will prompt you to choose between the two
before displaying the appropriate Saving screen.
To Next Page
Loading...
Need help?
General
