Sharp AJ-6020 - Hardware and Software Requirements; Pre-Installation Checks

26
HARDWARE AND SOFTWARE REQUIREMENTS
Check the following hardware and software requirements in order to install the AJ-6000
series drivers and software.
*1
Compatible with Windows Me, Windows 98 or Windows 2000 preinstalled model with
USB interface equipped as standard.
*2
At least 800 x 600dots (SVGA) is required to use Sharpdesk.
BEFORE INSTALLATION
Follow the steps shown below to install software.
1
Install the AJ-6000 series drivers after confirming the operating
system installed on your computer.
2
Install the AJ-6000 series software, which includes Button
Manager, Copy JX2, SHARP TWAIN, Sharpdesk, and the Online
Manual. (See page 37 - 38.)
3
Install the printer driver.
4
Install the bonus software. (See page 45.)
Computer type IBM PC/AT or compatible computer equipped with a
USB
*1
or bi-directional parallel interface (IEEE 1284)
Operating system Windows Me, Windows 98, Windows 95, Windows 2000,
Windows NT 4.0 (Service Pack 3 or later)
Display 640 x 480dots (VGA) or better
*2
Hard disk free space 80MB or more
Other requirement for hardware An environment on which any of the operating
systems listed above can fully operate
Windows Me
Windows 98
Windows 95
Windows 2000
Windows NT 4.0
USB/Parallel
USB/Parallel
Parallel
USB
Parallel
Parallel
Installing onto Windows Me (See page 27)
Installing onto Windows 98 (See page 28)
Installing onto Windows 95 (See page 29)
Installing onto Windows 2000 (USB interface)
(See page 31)
Installing onto Windows 2000 (Parallel interface)
(See page 32)
Installing onto Windows NT 4.0 (See page 33)
Operating system Interface Reference pages for how to install
Windows Me
Windows 98
Windows 95
Windows 2000
Windows NT 4.0
USB/Parallel
USB/Parallel
Parallel
USB/Parallel
Parallel
Installing onto Windows Me/98/95
(See page 39)
Installing onto Windows 2000/NT 4.0
(See page 41)
Operating system Interface Reference pages for how to install