74
THE PRINT HEAD
Changing the print head
Even after cleaning and aligning the print head, if copy quality remains poor, you have to
change the print head. Follow the steps below to change the print head.
1
Make sure that the power is on.
2
Open the front cover. (See page 13)
3
Open the maintenance cover. (See page 14)
4
Raise the print head latch. (See page 14)
5
Remove the old black or colour print head with the ink tank still
inserted.
lift it straight up to remove.
6
Remove the new print head from its protective case. (See page 14)
7
Insert the new print head. (See page 14)
8
Lower the print head latch. (See page 15)
9
Remove the ink tank(s) from the old print head (See page 71) and
insert them into the newly inserted print head (See page 15).
10
Close the maintenance cover. (See page 16)
11
Close the front cover. (See page 16)
If a message appears warning you that any of the ink tanks are not installed
correctly, return to step 2 and follow the procedures again.
To Next Page
Loading...
