Sharp AL-2021 Service Manual

AL-2041 DISASSEMBLY AND ASSEMBLY 8 - 6
4) Remove the screw and remove the resistor.
Remove the screw and remove the U-turn guide.
Note: Check to confirm that the fusing lower earth spring (A) does
not extend over the fusing bearing (B) after tightening the
screw.
Pressure roller section disassembly
5) Remove the three screws, remove the fusing cover lower on the
right side, and open the heat roller section.
6) Remove the screw and remove the PPD2 sensor.
7) Remove the plate spring on the right and remove the heater
lamp.
8) When opening the fusing unit, slide the fusing lower earth
spring in the arrow direction, and open the unit.
If the fusing unit is opened without sliding the fusing lower earth
spring, the fusing lower earth spring is deformed.
If the fusing lower earth spring is once deformed, the earth
function may not work properly. Replace the deformed spring
with a new one.
1)
2)
3)
A
B
1)
5)
5)
6)
6)
4)
3)
2)
1)
2)
PPD2 sensor
1)
2)
Heater lamp

Sharp AL-2021 Specifications

General

Brand	Sharp
Model	AL-2021
Category	All in One Printer
Language	English