Sharp AR-M550N - Page 276

: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 18
66 12 Used to check the output operation
of FAX G3 mode 300bps. (Used to
check the operation of MODEM.) An
output is send at the send level set
by the soft switch. (Only when FAX
is installed)
Operation test/Check FAX Operation
13 Used to enter (set) the number of
FAX dial signal output test. (The dial
number set by this simulation is
outputted when the dial signal output
test is made by SIM 66-14 - 16. )
(Only when FAX is installed)
Setting Data
14 Used to set the make time in the
FAX pulse dial mode (10pps) and to
test the dial signal output. (The dial
number signal set by SIM 66-13 is
outputted.) Used to check troubles in
dialing and to check the operation.
(Only when FAX is installed)
Setting/Operation test/
Check
FAX Operation
15 Used to set the make time in the
FAX pulse dial mode (20pps) and to
test the dial signal output. (The dial
number signal set by SIM 66-13 is
outputted.) Used to check troubles in
dialing and to check the operation.
(Only when FAX is installed)
Setting/Operation test/
Check
FAX Operation
16 Used to check the dial signal (DTMF)
output in the FAX tone dial mode.
(The dial number signal set by SIM
66-13 is outputted.) The send level
can be set to an optional level. Used
to check troubles in dialing and to
check the operation. (Only when
FAX is installed)
Setting/Operation test/
Check
FAX Operation
17 Used to check the dial signal (DTMF)
output in the FAX tone dial mode.
Send level: Max. Used to check the
operation. (Only when FAX is
installed)
Setting FAX Operation
18 Used to check the dial signal (DTMF)
output in the FAX tone dial mode.
An output is sent at the send level
set by the soft switch. Used to check
the operation. (Only when FAX is
installed)
Setting FAX Operation
19 Used to back-up the HDD data into
the Flash memory (optional FAX
expansion memory: AR-MM9). (Only
when FAX is installed)
Data transfer FAX Data
20
Used to read the back-up data by
SIM 66-19 to the SRAM/HDD. (Only
when FAX is installed)
Data transfer FAX Data
21 Used to print information related to
FAX (various registrations,
communication management, file
management, system error
protocol). (Only when FAX is
installed)
Adjustment/Setup/
Operation data output/
Check (Display/Print)
FAX Data
22 Used to adjust the handset volume.
(Only when the FAX is installed.)
Setting FAX Operation
23 Used to download the FAX program.
(Only when FAX is installed)
Not used in the market. (For
development)
Setting FAX
24 Used to clear the FAST memory
data. (Only when FAX is installed)
Clear FAX Data
Code
Function (Purpose) Purpose Section Item
Main Sub
1