: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 19
66 25 Used to register the FAX number for
Modem dial-in. (Only when FAX is
installed)
Not used in the market. (For
development)
Setting FAX Data
26 Used to register external telephone
numbers for Modem dial-in. (Only
when FAX is installed)
Not used in the market. (For
development)
Setting FAX Data
27 Used to register the transfer number
for voice warp. (Only when FAX is
installed)
Not used in the market. (For
development)
Setting FAX Data
28 Used to record voice messages.
(Only when FAX is installed.)
Setting FAX Data
29 Used to clear data related to an
address book (one-touch
registration, program registration/
expansion, relay memory box
registration, each table content).
Clear FAX Data
30 Used to check the change in the
TEL/LIU status.
Operation test/Check FAX Operation
31 Used to check the relay operation. Operation test/Check FAX Operation
32 Used to check the receive data (fixed
data) from the line.
Operation test/Check FAX Operation
33 Used to check the signal (BUSY
TONE/CNG/CED/FNET/DTMF)
detection.
Operation test/Check FAX Operation
34 Used to measure the communication
time of test image data.
Operation test/Check FAX Operation
35 Modem program reloading (Only
when FAX is installed)
Not used in the market. (For
development)
Setting FAX Data
36 Used to check interface between
MFPC controller and MDMC. (Check
of the data line or the command line)
Operation test/Check FAX Operation
39 Used to set the destination
specifications.
Setting FAX Specifications Operation
60 Used to set the ACR data. Setting FAX Operation
67 2 Used to check the operation of the
parallel I/F of the printer. (This
simulation is for production only, and
requires a special tool for execution.
Not used in the market.)
Operation test/Check MFP controller Operation Interface/
Communicatio
n
11 Used to set YES/NO of the parallel I/
F select signal of the printer.
Setting MFP controller Operation Interface/
Communicatio
n
16 Used to check the operation of the
network card.
Operation test/Check MFP controller Operation Interface/
Communicatio
n
Code
Function (Purpose) Purpose Section Item
Main Sub
To Next Page
Loading...
